| Max output Power EIA 1kHz 1% THD (EIA = 33ms ON / 66ms OFF) |
2x 2500W 8 ohms | 2x 4000W 4 ohms | 2x 4000W 2 ohms (not recommended) |
| Overall gain |
34dB (50 times voltage) |
| Sensitivity at 8 ohms |
2.82Vrms (+11dBu) |
| Signal to Noise Ratio (A weighted) |
115dB |
| Frequency Response (-1dB) |
20~25000Hz |
| Typical THD (half power, 1kHz, 8 ohms) |
<0.05% |
| Typical IMD (1kHz at 4:1, -20dB) |
<0.2% |
| Crosstalk (1kHz) |
>75dB |
| Slew Rate |
>60V/us |
| Input Impedance |
20 kΩ |
| Damping factor (1kHz, 8 ohms) |
Soft-Start, Short-Circuit, Over and Under-Voltage, Over-Current, Over-Load, DC Output, Temperature, SOM (Smart Overhead Management) |
| Operating Voltage |
190~250VAC 50-60Hz |
| Preamp |
Proprietary PureSound Circuit for unmatched sound quality (Audiophile capacitors in signal path, High Voltage Opamps, Ultra Low Noise design), Studio grade TrueRMS VCA limiter, Continuous protection, RF protection, Overload protection |
| Power Supply (PSU) |
Advanced Switch Mode with 3D-Guard tracking, 105C long life SuperCharged Capacitors |
| Output stage |
Fully Discrete 4th generation proprietary Class D (93% efficiency at full power), Differential circuit for Load-Independent linear frequency response, Half bridge design with high-Speed high-Current MOSFETs, 105C Long Life capacitors |
| Cooling |
Front to back airflow Temperature regulated SUNON MagLev fans (50000 Hours, dustproof) FEA optimized Radial heat-sink for maximum heat transfer |
| Rear Panel |
2 NEUTRIK XLR Input with latch, 2 NEUTRIK XLR Link, 2 NEUTRIK Speakon NL4, PowerCon 20A (included) |
| SpeakonWiring |
SPK1 = 1+1- CH A / 2+2- | CH B SPK2 = 1+1- CH B / 2+2- Not Used |
| Chassis |
19" 2U height, 468mm total depth |
| Weight Net / Gross |
13kg / 16kg |
CELTO Touring Series Specs 2018-12-05.pdf
CELTO Touring Series Specs 2018-12-05.pdf
